Dynam GAVIN-8C 8CH transmitter + SR86A 8CH receiver with Istone stabalizer (W/ABS system) transmitter set

Introduction

GAVIN-8C is a 2.4GHz 8-channel transmitter, applicable for airplane, helicopter and multi-copter. Based on the GAVIN-6C, GAVIN-8C adds the two channels and its response time achieves 2.6ms, even 8 channels it acts synchronously. Also, AA battery, Ni-MH battery and Li-Po battery all can be used in this transmitter to satisfy more customer needs.

Using the DSSS&FHSS dual spread spectrum technology,  will enhance the transmitter by increasing the anti-interference performance and transmission distance, even can controlled normally in city center, do not worry about the strong interference from high voltage lines, signal towers, city WiFi, etc.

SR86A is an 8-channel 2.4GHz receiver integrated with 6-axis gyro and suitable for normal wing, fly-wing, and V-tail airplanes. It provides four different flight modes: Gyro off, Normal, Aerobatic, and Auto-Recovery (Auto Balance) and can be programmable from the matched transmitter.

Features

GAVIN-8C transmitter

- Applicable for airplane, helicopter and multi-copter.

- 30 model memory.

- Adopting 2.4GHz direct sequence spread spectrum (DSSS) and multiple frequency-hopping spread spectrum (FHSS) technology, the R/C system has high receiving sensitivity and strong anti-interference capability, can support a stable operating for more than 1km on the ground and more than 1.6km in the air.

- Adopting wireless chips, with extended power amplifier (PA) and low noise amplifier (LNA) can extremely improve the system output power and receiving sensitivity.

- Using all-band antenna on transmitter. The transmitting efficiency is greatly improved.

- Can experience a smooth flight operation by using the 4096 section precision sticks and selecting four stick modes.

- Achieving 2.6ms response time, even 8 channels it acts synchronously.

- USB upgrade function always keeps your GAVIN-6C the latest program.

- Support Fail Safe function, which could predefine the servo position by transmitter when receiver out of control.

- Trainer function make a skilled instructor can teach a student with fly skills.

- Can be used to set the programmable item of the flight controller for airplane.

- AA, Ni-MH and Li-Po battery all ca be used for customer.

SR86A sport receiver

- Adopt 32-bit high-performance ARM core processor, 6-axis MEMS gyro chipset

- Original airplane attitude stabilization algorithm and control algorithm. Support normal wing, fly wing, V-tail airplanes and 3D planes.

- Support four flight modes: Gyro off, Normal, Aerobatic and Auto-Recovery (Auto Balance).

- Set the gain and other programmable items with matched transmitter.

- Adopt 2.4GHz direct sequence spread spectrum (DSSS) and multiple frequency-hopping (FHSS) technologies, having high receiving sensitivity and strong anti-interference.

- Diversity antenna, combined with the signal detection and switching algorithm, guarantees the stable and reliable receiving signal.

- Each ID code of transmitter can be stored in receiver and no further binding after restarting the receiver.

- The receiver will move the servos to predefined position when the aircraft flies out of range and cannot receive a valid RF signal from transmitter.

Specifications

GAVIN-8C

Channel: 8-channel

Transmitting frequency: 2.4GHz

Power supply: AA batteries 4*1.5V, Ni-MH batteries 4*1.2V, 2S Li-Po

Consuming current: less than or equal to 120mA (test mode); less than or equal to 230mA (operating mode).

Output power: 10mW (test mode); 100mW (operating mode).

Output pulse: 1000ms~2000ms (neutral 1500ms)

SR86A sport receiver

Channel: 8-channel

Sensor: 6-axis gyro

Sensitivity: -97dBm

Output: PWM (71Hz)

Transmission Range: more than 1km on the ground, more than 1.6km in the air.

Input Voltage: 3.6V~16V

Size: 51mm*28.4mm*14.5mm

Weight: 15g

Packing lists

GAVIN-8C transmitter  ×1

DETRUM SR86A receiver  ×1

Introduction Manual  ×1

Simulator Converter  ×1 (optional)

9g Servo  ×4 (optional)